How to launch a pizza into the oven step by step
What do I need before I launch?
A hot oven, a floured peel, and a pizza that already moves. Skip any of those and the rest gets harder.
One maker says you want pizzas to go into a hot oven with a pre-heated pizza stone, so turn the oven on once your dough is ready to be worked.1 Follow your own manual for lighting, heat-up time and where the oven can be used. This page covers the peel only.
How do I launch, step by step?
These steps are combined from two oven makers' launching guides, so they aren't one maker's own sequence.
- Stretch the dough, then move it to the peel before toppings. One guide says to shape the dough on a clean, floured surface and transfer it to the peel before adding toppings. Flour the peel well first.1
- Stop and shake. Before sauce and toppings go on, pick up the peel and give it a shake. If the dough stays stuck, lift the edge and add flour. You can't do this once toppings are on.2
- Keep toppings light. Heavy toppings make the pizza harder to slide off.1
- Shake now and then. While you add toppings, give the peel a little shake every so often to check nothing is starting to stick. If something is, lift an edge and put more flour under it.1
- Hold the peel at a slight angle. The maker says to hold it at only a very slight angle.1
- Give one quick shake. One quick shake slides the pizza onto the stone in one swift movement.1
- If it lands off-centre, leave it. If the pizza doesn't land in the middle, don't worry about it yet. The same maker says to let it cook a bit before trying to move it.1
Is there a trick for a pizza that clings?
One guide describes a "hovercraft" method. You lift one edge of the pizza base and gently blow air under the dough. That makes air pockets and spreads flour on the underside to any spots that might be sticking.2
It can help to add a little extra flour on the peel on the side you'll blow from.2
Why a slight angle and a quick motion?
The maker doesn't explain why, but its wording is clear: a very slight angle, a single quick shake, and the pizza goes onto the stone "in one swift movement".1
Reach is part of a peel's purpose too.3 So aim for where you want the pizza to land, then slide it in one motion.
How can I practise without wasting dough?
Use something else. The maker suggests putting a folded-up kitchen towel on the peel and practising sliding it off. You can do it at the height of your oven, or even into the oven when it's cold.1
A note on safety. Once the oven is lit, follow your manual about distance, gloves and where to stand. It also says where your oven can be used, and fuel-burning ovens belong outdoors.
What if the pizza lands crooked?
Leave it. The maker says not to worry if it lands off-centre. Give it time on the stone first.1 After that you can turn it, as covered in the turning page.
What if it sticks halfway?
Stopping the stick starts earlier than the launch. Go through the causes makers list, and check which dusting you use.
Notes and sources
- Tips for Launching Pizza, Fontana Forni USA
- 9 Tips for Launching the (Almost) Perfect Pizza, Ooni Europe
- Peel (tool), Wikipedia